Cloos QINEO NexT - SD module

152
SD module
Each electronically controlled Qineo welding power source can be equipped
with a hardware to monitor weld data. This hardware is already integrated
in the devices of the Qineo NexT Premium series.
If all necessary components are connected to the welding power source
and enabled by software, the display of the Premium operating module
shows the function "SD monitoring" in the "Main (3)" menu, see Figure 112.
If the display shows "SD monitoring" in grey, the SD module was not recog-
nised by the controller or the option was not enabled.
The following monitoring channels are available, see Figure 113.
SD
Ü
ber
-
wachung
M A I N (3)
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
SD
Ü
ber
-
wachung
M A I N (3)
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
Figure 112. Menu
3. SD module
3.1 Monitoring channels
Anzeige
Sollwert
übernahme
Reset
Einricht
betrieb
Puls Extern
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
SD - Monitor
Gas
Spannung
Drahtvorschub
Strom
Reserve1
Logbuch
Motorstrom QWD
Motorstrom CDD
Reserve2
24.09.2010
13:15
Drahtvorrat
Lichtbogenabriss
Schweißzeit
Zünden
+
_
+
_
+
_
+
_
+
Anzeige
Sollwert
übernahme
Reset
Einricht
betrieb
Puls Extern
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
SD - Monitor
Gas
Spannung
Drahtvorschub
Strom
Reserve1
Logbuch
Motorstrom QWD
Motorstrom CDD
Reserve2
24.09.2010
13:15
Drahtvorrat
Lichtbogenabriss
Schweißzeit
Zünden
+
_
+
_
+
_
+
_
+
_
+
_
+
_
+
_
++
Figure 113. SD menu with selected monitoring channels