Codan HF SSB User Manual

Display messages
10-2 HF SSB transceiver reference manual
Message Meaning Action
ALE ACK
timeout
The transceiver cannot
communicate with the 9300
ALE controller.
If the 9300 ALE controller is
connected, check the cables
between the ALE and
transceiver. If no ALE is
connected, see Chapter 7,
RS-232 connected equipment to
remove ALE from the setup. If
you need help, contact your
Codan agent.
ALE not
initialised
The 9300 ALE controller
has not been initialised.
To initialise the ALE controller,
switch it off and then on again.
If no ALE controller is
connected, see Chapter 7,
RS-232 connected equipment to
remove ALE from the setup.
Antenna
untuned
The auto tuner or antenna
is not tuned.
Press the Tune button to tune
the antenna.
Auto-tuning The antenna is
automatically being tuned
prior to transmitting.
None.
Bad ALE ACK The transceiver cannot
communicate with the 9300
ALE controller.
If the 9300 ALE controller is
connected, check the cables
between the ALE and
transceiver. If no ALE is
connected, see Chapter 7,
RS-232 connected equipment to
remove ALE from the setup. If
you need help, contact your
Codan agent.
Bad ALE SCall
channel
A channel in the ALE scan
table has not been assigned
to a selcall group.
Assign a selcall group (S1–S5)
to this ALE selcall channel. See
Chapter 8, Selcall address setup.
Display messages
10-2 HF SSB transceiver reference manual
Message Meaning Action
ALE ACK
timeout
The transceiver cannot
communicate with the 9300
ALE controller.
If the 9300 ALE controller is
connected, check the cables
between the ALE and
transceiver. If no ALE is
connected, see Chapter 7,
RS-232 connected equipment to
remove ALE from the setup. If
you need help, contact your
Codan agent.
ALE not
initialised
The 9300 ALE controller
has not been initialised.
To initialise the ALE controller,
switch it off and then on again.
If no ALE controller is
connected, see Chapter 7,
RS-232 connected equipment to
remove ALE from the setup.
Antenna
untuned
The auto tuner or antenna
is not tuned.
Press the Tune button to tune
the antenna.
Auto-tuning The antenna is
automatically being tuned
prior to transmitting.
None.
Bad ALE ACK The transceiver cannot
communicate with the 9300
ALE controller.
If the 9300 ALE controller is
connected, check the cables
between the ALE and
transceiver. If no ALE is
connected, see Chapter 7,
RS-232 connected equipment to
remove ALE from the setup. If
you need help, contact your
Codan agent.
Bad ALE SCall
channel
A channel in the ALE scan
table has not been assigned
to a selcall group.
Assign a selcall group (S1–S5)
to this ALE selcall channel. See
Chapter 8, Selcall address setup.

Codan HF SSB Specifications

General

Brand	Codan
Model	HF SSB
Category	Transceiver
Language	English