Codan HF SSB User Manual

Display messages
10-4 HF SSB transceiver reference manual
Message Meaning Action
Clarifier Clarifier mode has been
selected.
Clarify by using the Select knob
on the control panel. Refer to the
HF SSB transceiver user guide,
Chapter 3, Using Clarifier mode.
Cloning failed Cloning the transceiver has
failed.
Check the programming cables.
Switch the transceiver off and
then on again. Try cloning
again. If the problem remains,
contact your Codan agent for
help.
Cloning
finished
Cloning has completed
successfully.
None.
Completed The transceiver has
finished loading
information from the 9300
ALE controller.
None.
Data The transceiver is in Data
mode.
None.
Disconnect Err The transceiver received a
message to disconnect the
call when no IPC-500 was
in operation.
If the problem persists, contact
your Codan agent for help.
Emergency
abort
The emergency call was
cancelled.
None.
Empty scan
table
No channels have been set
up in the selected scan
table.
To set up a scan table, see
Chapter 3, Scan table creation.
Error PIN
mismatch
You entered a different
number the second time
you entered your new PIN.
Set up the PIN again. See
Chapter 9, PIN setup.
Error: no self
ID
Your address has not been
set up.
See Chapter 8, Selcall address
setup.
Display messages
10-4 HF SSB transceiver reference manual
Message Meaning Action
Clarifier Clarifier mode has been
selected.
Clarify by using the Select knob
on the control panel. Refer to the
HF SSB transceiver user guide,
Chapter 3, Using Clarifier mode.
Cloning failed Cloning the transceiver has
failed.
Check the programming cables.
Switch the transceiver off and
then on again. Try cloning
again. If the problem remains,
contact your Codan agent for
help.
Cloning
finished
Cloning has completed
successfully.
None.
Completed The transceiver has
finished loading
information from the 9300
ALE controller.
None.
Data The transceiver is in Data
mode.
None.
Disconnect Err The transceiver received a
message to disconnect the
call when no IPC-500 was
in operation.
If the problem persists, contact
your Codan agent for help.
Emergency
abort
The emergency call was
cancelled.
None.
Empty scan
table
No channels have been set
up in the selected scan
table.
To set up a scan table, see
Chapter 3, Scan table creation.
Error PIN
mismatch
You entered a different
number the second time
you entered your new PIN.
Set up the PIN again. See
Chapter 9, PIN setup.
Error: no self
ID
Your address has not been
set up.
See Chapter 8, Selcall address
setup.

Codan HF SSB Specifications

General

Brand	Codan
Model	HF SSB
Category	Transceiver
Language	English