Codan HF SSB User Manual

Display messages
10-6 HF SSB transceiver reference manual
Message Meaning Action
Loading ALE
data
The transceiver is loading
information from the 9300
ALE controller.
Wait for loading to finish.
Low battery The battery voltage has
dropped below 10 volts.
Recharge or change the battery.
No ALE scan
table
No channels have been set
up in the ALE scan table.
To set up an ALE scan table, see
Chapter 3, Scan table creation
(set scan type
ALE
).
No call
available
Either selective calling has
not been enabled or no
selcall group is assigned to
this channel.
For changing channel settings,
see Chapter 3, Channel creation
and editing. Select one of the
selcall groups S1–S5. If the
channel is protected, contact
your Codan agent for help.
No channels
fitted
No channels have been set
up in the transceiver.
Contact your Codan agent for
help.
No deflt rec for
XX
The transceiver could not
read a default record.
Switch the transceiver off and
then on again. If the problem
remains, contact your Codan
agent for help.
No destination
ID
No address to call has been
set up.
Refer to the HF SSB transceiver
user guide, Chapter 4, Selcall
for how to enter the address of
the station you want to call.
No external
unit connected
The remote station is not
configured to respond.
None.
Display messages
10-6 HF SSB transceiver reference manual
Message Meaning Action
Loading ALE
data
The transceiver is loading
information from the 9300
ALE controller.
Wait for loading to finish.
Low battery The battery voltage has
dropped below 10 volts.
Recharge or change the battery.
No ALE scan
table
No channels have been set
up in the ALE scan table.
To set up an ALE scan table, see
Chapter 3, Scan table creation
(set scan type
ALE
).
No call
available
Either selective calling has
not been enabled or no
selcall group is assigned to
this channel.
For changing channel settings,
see Chapter 3, Channel creation
and editing. Select one of the
selcall groups S1–S5. If the
channel is protected, contact
your Codan agent for help.
No channels
fitted
No channels have been set
up in the transceiver.
Contact your Codan agent for
help.
No deflt rec for
XX
The transceiver could not
read a default record.
Switch the transceiver off and
then on again. If the problem
remains, contact your Codan
agent for help.
No destination
ID
No address to call has been
set up.
Refer to the HF SSB transceiver
user guide, Chapter 4, Selcall
for how to enter the address of
the station you want to call.
No external
unit connected
The remote station is not
configured to respond.
None.

Codan HF SSB Specifications

General

Brand	Codan
Model	HF SSB
Category	Transceiver
Language	English