Codan HF SSB User Manual

Using Setup mode procedures
HF SSB transceiver reference manual 4-5
Procedure Page Setup
code
Description
Password entry to
enable transceiver
options (standard)
7-5 42 Enables transceiver options that are built into
the transceiver and deletes forgotten PINs.
Power up message
on/off (standard)
7-10 34411 Allows you to set up a message that is
displayed for several seconds when the
transceiver is first switched on.
Power up mute
setting (standard)
7-13 34412 Selects the initial mute setting that is used
when the transceiver is first switched on.
Power up address
display on/off
7-16 34413 Selects whether or not your address, set up in
selcall group 1, is briefly displayed when the
transceiver is first switched on.
PTT release beep
on/off (standard)
7-18 3432 Switches on or off PTT release beeping.
PTT transmit
cut-out (standard)
7-20 3431 Prevents the transceiver from being left on in
the transmit state by mistake.
Recall channels by
frequency on/off
(standard)
7-22 32 Selects whether or not you can recall
channels by frequency.
RF gain on/off
(standard)
7-24 3443 Switches on or off the RF gain.
RS-232 connected
equipment
(standard)
7-26 3411 Identifies the equipment connected to either
the RS-232 socket or GP connector on the
transceiver rear panel.
RS-232 connection
baud rate
(standard)
7-29 3412 Sets the speed of information transfer for
equipment connected to the transceiver rear
panel.
Using Setup mode procedures
HF SSB transceiver reference manual 4-5
Procedure Page Setup
code
Description
Password entry to
enable transceiver
options (standard)
7-5 42 Enables transceiver options that are built into
the transceiver and deletes forgotten PINs.
Power up message
on/off (standard)
7-10 34411 Allows you to set up a message that is
displayed for several seconds when the
transceiver is first switched on.
Power up mute
setting (standard)
7-13 34412 Selects the initial mute setting that is used
when the transceiver is first switched on.
Power up address
display on/off
7-16 34413 Selects whether or not your address, set up in
selcall group 1, is briefly displayed when the
transceiver is first switched on.
PTT release beep
on/off (standard)
7-18 3432 Switches on or off PTT release beeping.
PTT transmit
cut-out (standard)
7-20 3431 Prevents the transceiver from being left on in
the transmit state by mistake.
Recall channels by
frequency on/off
(standard)
7-22 32 Selects whether or not you can recall
channels by frequency.
RF gain on/off
(standard)
7-24 3443 Switches on or off the RF gain.
RS-232 connected
equipment
(standard)
7-26 3411 Identifies the equipment connected to either
the RS-232 socket or GP connector on the
transceiver rear panel.
RS-232 connection
baud rate
(standard)
7-29 3412 Sets the speed of information transfer for
equipment connected to the transceiver rear
panel.

Codan HF SSB Specifications

General

Brand	Codan
Model	HF SSB
Category	Transceiver
Language	English