ComAp InteliLite NT AMF26-P - Page 145

InteliLite
NT
AMF26-P, SW version 2.4, ©ComAp – January 2016 145
AMF26-P-2.4 Reference Guide.pdf
T … time delay in sec (in range 1 to 600)
Example: #5:accesscode d 10
Request 10 sec delay before serving next SMS command.
Return code: d_ok … time delay was successful performed
d_over … requested time delay is out of range (1 to 600 sec)
Note: Any other SMS messages are not served during time delay!
9. Remote switches (IG/IS-NT only)
Set or reset RemoteControl1-8 output.
Syntax: s 1/0
s … command
1/0 … set/reset
Example: #5:accesscode p0, s1 1
Enters password p0 and sets RemoteControl1 output.
Return code: p_OK,s_OK
10. ExtValues (IG/IS-NT only)
Enters value to ExtValue.
Syntax: e xxx
e … command
xxx … value
Example: #5:accesscode p0, e1 50
Enters password p0 and sets ExtValue1 = 50.
Return code: p_OK,e_OK
11. Help (IG/IS-NT only)
Request for list of supported SMS command.
Syntax: ?
Example: #5:accesscode ?
Return code: ?=(p <user:>passwd,r comm_obj,w com_obj val,c cmd_num,d sec,a,sx y,ex
y,?)…...
..... list of supported SMS commands
Note: Return code is not separated to more message.
12. Answer message
Answer message start with # character followed by Gen-set name. Colon separates this
header form return codes of SMS commands. Answer message is generated during serving of
received message and is sent in case that 160 characters or end of received message are
achieved. Answer message is sent to the originator phone number. Tree dots at the end of
message indicate separation and next following message.
Example: #5:accesscode r8252,w8252 100,r8252
answer message