ComAp InteliLite NT AMF26-P - Page 151

InteliLite
NT
AMF26-P, SW version 2.4, ©ComAp – January 2016 151
AMF26-P-2.4 Reference Guide.pdf
Hint:
From it’s nature the GPRS connection can from time to time drop for a short time due to a number of
reasons affecting the cellular network. However the system is designed in the way that controller will
automaticaly reconnect back.
Hint:
I tis highly recomended to use numbers in initernation format and start to fill in phone numbers from
the first communication channel.
GSM Diag Code – Diagnostic code for IL-NT-GPRS modem Table of Diagnostic Codes:
Code
Description
0
OK. No error
1
Not possible to hang up
2
IL-NT-GPRS is switched off
3
IL-NT-GPRS is switched on
4
IL-NT-GPRS – error in initialization
5
IL-NT-GPRS – not possible to set the APN
6
IL-NT-GPRS – not possible to connect to GPRS network
7
IL-NT-GPRS – not possible to retrieve IP address
8
IL-NT-GPRS – not accepted DNS IP address
9
Error in modem detection
10
Error in initialization of analog modem
11
SIM card is locked (Possibly PIN code required, PIN needs to be deactivated) or
unknown status of SIM locking
12
No GSM signal
13
Not possible to read the SIM card parameters
14
GSM modem did not accepted particular initialization command, possibly caused by
locked SIM card
15
Unknown modem
16
Bad answer to complement initialization string
17
Not possible to read GSM signal strength
18
CDMA modem not detected
19
No CDMA network
20
Unsuccesful registration to CDMA network
255
Only running communication is needed to indicate