InteliLite
NT
AMF26-P, SW version 2.4, ©ComAp – January 2016 94
AMF26-P-2.4 Reference Guide.pdf
Red Alarm Msg [DISABLED / ENABLED]
Set this setpoint to YES if you want to get messages when a red (shutdown) alarm occurs.
Hint
The target address (GSM phone number or e-mail address) must be set correctly to the setpoint(s)
TelNo/Addr Ch1-4
Event Msg [ON/OFF]
Set this setpoint to ON if you want to get messages when a new event occur .
TelNo/Addr Ch 1,2,3,4
Enter either a valid GSM phone number or e-mail address to this setpoint, where the alarm messages
shall be sent. Type of active call is considered from the value of this parameter. If it consist „@“ it is
supposed to be e-mail address and active e-mail is sent. If the value is number, without „@“, it is
supposed to be the telephone number and active SMS is sent.
Hint:
For GSM numbers use either national format (i.e. like number you will dial if you want to make a local
call) or full international format with "+" character followed by international prefix in the begin.
Communication channels have to be used in order 1,2,3,4. It is not recommended to leave channels
1,2 blank and and use only 3,4.
Phone numbers can be modified from controller display, but in case of email address this
setpoint can be modified from PC only!
Following buttons are used for phone number modification
- ENTER for - opening the modification
- confirmation of particular number change and jump to the next position
- confirmation of the last number and closing of the modification
- n and p for - particular number change
Particular numbers can take values: from “0” to “9”, “+” symbol and empty space.
Report Period [h]
Automatic periodical SMS report sending period. The period is always counted from 2 AM. When set
to 0 the automatic sending is disabled. When analog inputs’ values are out of the range their values
are not represented by “####” as in LiteEdit or on controller display, but by value -32768. In case the
message is not send following alarm and history record appears SmsRprtCH1Fail or SmsRprtCH2Fail.
Step: 1 h
Range: 0 – 1000 h
To Next Page
Loading...
