Ctera C800 - Viewing Network and Port Settings

Managing Network Settings 14
CTERA C-Series User Guide 267
Select Automatic to configure the port to automatically detect the link speed and
duplex.
This is the default.
Select the desired link speed and duplex.
5 To use jumbo frames, do the following:
a Select the Use Jumbo frames check box.
b In the MTU field, type the maximum transmission unit in bytes.
6 Click Save.
Viewing Network and Port Settings
You can view the appliance's network and port settings.
To view network and port settings
In the Configuration tab's navigation pane, click System > Network.
The System > Network page appears.
The following information is displayed:
Table 53: Network Status Information
This field...
Displays...
Network
Connected / Disconnected
The status of the appliance's network connection (Connected or
Disconnected),
IP Address
The appliance's IP address.
Default Gateway
The IP address of the default gateway.
DNS Servers
The IP addresses of the primary and secondary DNS servers.
Connection Duration
The amount of time that the appliance has been connected to the
network.
Ports
Mbps, Duplex
The current Ethernet link speed and duplex.
MAC Address
The MAC address of this appliance.