5 Remove the hard drive from the disk tray.
6 Slide the disk tray back into the C800.
7 Press the disk tray lever back into place, until you hear a click.
Connecting USB Drives
If desired, you can connect a USB drive to the appliance.
To connect a USB drive to the appliance
1 Connect one end of a USB cable into the USB drive.
2 Connect the other end of the USB cable to one of the appliance's USB port.
Hot Swapping Power Supplies
You can replace a power supply while the appliance is on.
To hot swap a power supply
1 Remove the power supply as follows: Press the power supply's unlock lever downwards,
while simultaneously pulling on the power supply's handle.
2 Install a new power supply as follows: Insert the power supply into the power supply slot,
while simultaneously pressing the power supply's unlock lever downwards.
Muting the Power Supply Alarm
The CTERA C800 alerts you when a power supply fails or loses input power, by sounding an
alarm. You can mute this alarm.
To mute the power supply alarm
On the C800's rear panel, press the Mute Alarm button.
The alarm stops.
To Next Page
Loading...
