78 CTERA C-Series User Guide
Select this option limit the amount of storage space allocated to
each volume user. Each user can then be allocated a specific
storage space quota, as described in Allocating Disk Quotas to
Users (on page 256).
If quotas are not enabled, then each user will be able to use
unlimited amount of space on this volume.
To set a default storage space quota for volume users, select
this option and then type the desired default quota in MB in the
field. This quota will be allocated to each user by default.
If this option is not enabled, then an unlimited amount of space
will be allocated to each user by default.
In either case, the default allocated quota can be overridden, as
described in Allocating Disk Quotas to Users (on page 256).
Deleting Logical Volumes
To delete a logical volume
1 In the Configuration tab's navigation pane, click Storage > Volumes.
The Storage > Volumes page appears.
2 Select the desired volume and click Delete.
A confirmation message appears.
3 Click Yes.
The volume is deleted.
Scanning and Repairing Logical Volumes
You can scan the file system on a volume for errors. Any detected errors are automatically
repaired, if possible.
The scan and repair utility supports both EXT3 and NEXT3 volumes.
During the scanning process, the volume is taken offline. Do not turn off the
appliance, while the volume is being scanned.
To scan and repair a volume
1 In the Configuration tab's navigation pane, click Storage > Volumes.
The Storage > Volumes page appears.
2 Select the desired volume and click Repair.
To Next Page
Loading...
