Axis Display For parameter information - Refer to the Chapter – ISM8
Invert Channel Direction For parameter information - Refer to the Chapter – ISM8
Channels
*Acceleration For parameter information - Refer to the Chapter – ISM8
*Deceleration For parameter information - Refer to the Chapter – ISM8
*Up Speed For parameter information - Refer to the Chapter – ISM8
*Down Speed For parameter information - Refer to the Chapter – ISM8
Up Current Limit For parameter information - Refer to the Chapter – ISM8
Down Current Limit For parameter information - Refer to the Chapter – ISM8
Endstop Autodetect For parameter information - Refer to the Chapter – ISM8
Actuator Endstop Timeout For parameter information - Refer to the Chapter – ISM8
Intelligent Seating Module
Global
*Actuator Mode Entry Axis Sets the default axis when Seating Mode is entered
Axis Setup
Axis Channels Sets which actuator motor channels on the ISM will operate for a particular axis
Axis Display Sets the user display for a particular axis
Invert Axis Direction Sets whether a channel direction is inverted for a particular axis
Axis Name Sets the text that will be displayed when an actuator is selected
Channels
*Acceleration Sets the acceleration for each actuator channel
*Deceleration Sets the deceleration for each actuator channel
*Up Speed Sets the speed in the up direction for each actuator channel
*Down Speed Sets the speed in the down direction for each actuator channel
Up Current Limit Sets the maximum current output in the up direction for each actuator channel
Down Current Limit Sets the maximum current output in the down direction for each actuator channel
Endstop Autodetect Sets if the automatic endstop function for a particular actuator channel operates
Actuator Endstop Timeout Sets the period of time before the drive is cut at an endstop position
Seating Module
Global
Actuator Mode Entry Axis For parameter information - Refer to the Chapter – ELPM 90, JSM-LED & SM
Axis Setup
Axis Enabled For parameter information - Refer to the Chapter – ELPM 90, JSM-LED & SM
Up Speed For parameter information - Refer to the Chapter – ELPM 90, JSM-LED & SM
Down Speed For parameter information - Refer to the Chapter – ELPM 90, JSM-LED & SM
Axis End force
Actuator Endstop Timeout For parameter information - Refer to the Chapter – ELPM 90, JSM-LED & SM
Axis Display For parameter information - Refer to the Chapter – ELPM 90, JSM-LED & SM
Axes Inhibits
Up Assign For parameter information - Refer to the Chapter – ELPM 90, JSM-LED & SM
Up: Inhibit in bands For parameter information - Refer to the Chapter – ELPM 90, JSM-LED & SM
Down Assign For parameter information - Refer to the Chapter – ELPM 90, JSM-LED & SM
Down: Assign in bands For parameter information - Refer to the Chapter – ELPM 90, JSM-LED & SM
Battery
Low Battery Alarm Sets whether there will be an audible alarm to signal a low battery condition
Low Battery Flash Level Sets the point at which the battery gauge on the LCD screen starts to flash
Cable Resistance Calibrates the system to compensate for the electrical resistance of the battery cables
Calibration Factor Allows further fine calibration of the battery gauge
Low Voltage Cut-out Sets the voltage level at which the low voltage timer will start
Low Voltage Time Sets the period of time that the voltage must be below the above parameter before drive is cut
General
Brake Disconnected Alarm Sets whether there is an audible alarm when a brake(s) is disconnected
Brake Fault Detect Sets whether the Power Module will detect electrical faults in the wheelchair’s brakes
Brake Voltage Sets the voltage output from the Power Module to the wheelchair’s electrical brakes
Soft Stop Rate Sets the deceleration rate that is used while the wheelchair is “soft-stopping”
To Next Page
Loading...
Need help?
General
