D-Link xStack DES-3528 Series Reference Guide

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
119
The fields that can be configured are described below:
Parameter Description
MLD Snooping State
Click the radio buttons to enable or disable the MLD snooping state.
Max Learning Entry Value
(1-1024)
Enter the maximum learning entry value.
Click the Apply button to accept the changes made for each individual section.
Click the Edit button to configure the MLD Snooping Parameters Settings for a specific entry.
Click the Modify Router Port link to configure the MLD Snooping Router Port Settings for a specific entry.
After clicking the Edit button, the following page will appear:
Figure 4-55 MLD Snooping Parameters Settings window
The fields that can be configured or viewed are described below:
Parameter Description
VID
Specify the name of the VLAN ID.
VLAN Name
Specify the name of the VLAN for which IGMP snooping querier is to be configured.
Rate Limit
This displays the rate of IGMP control packets that the Switch can process on a
specific VLAN. The rate is specified in packet per second. The packets that exceed
the limited rate will be dropped.
Querier IP
Displays the querier IP address
Querier Expiry Time
Displays the querier expiry time.
Query Interval (1-65535)
Specify the amount of time in seconds between general query transmissions. The
default setting is 125 seconds.
Max Response Time (1-
25)
The maximum time in seconds to wait for reports from listeners. The default setting is
10 seconds.
Robustness Value (1-7)
Provides fine-tuning to allow for expected packet loss on a subnet. The value of the
robustness variable is used in calculating the following MLD message intervals:
Group listener interval - Amount of time that must pass before a multicast router
decides there are no more listeners of a group on a network.
Other Querier present interval - Amount of time that must pass before a multicast
router decides that there is no longer another multicast router that is the Querier.
Last listener query count - Number of group-specific queries sent before the router
assumes there are no local listeners of a group. The default number is the value of
the robustness variable.

D-Link xStack DES-3528 Series Specifications

General

Brand	D-Link
Model	xStack DES-3528 Series
Category	Switch
Language	English