Daewoo NUBIRA - Brake Pedal Removal; Stoplamp Switch Installation; Stoplamp Switch Removal

HYDRAULIC BRAKES 4A – 17
DAEWOO V–121 BL4
STOPLAMP SWITCH
Removal Procedure
1. Disconnect the negative battery cable.
2. Disconnect the connector from the stoplamp switch.
3. Rotate the switch and remove it from the brake
pedal bracket.
Installation Procedure
1. Insert the stoplamp switch into the brake pedal
bracket and rotate the switch to lock it.
2. Connect the electrical connector to the stoplamp
switch.
3. Press the brake pedal and pull the switch plunger to
its maximum setting to adjust the switch.
4. Release the plunger and pull up on the pedal.
5. Connect the negative battery cable.
BRAKE PEDAL
Removal Procedure
1. Remove the stoplamp switch.