DOORS 9P – 23
DAEWOO V–121 BL4
POWER REAR WINDOW
REGULATOR
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the rear door glass. Refer to Section 9L,
Glass and Mirrors.
3. Disconnect the electrical connector.
4. Remove the nuts and the window regulator.
Installation Procedure
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
1. Install the window regulator with the nuts.
Tighten
Tighten the window regulator nuts to 8 NSm (71 lb–in).
To Next Page
Loading...
