Daewoo NUBIRA - Front Bumper Impact Bar Installation

BUMPERS AND FASCIAS 9O – 7
DAEWOO V–121 BL4
4. Remove the front impact bar bolts.
5. Remove the impact bar.
Installation Procedure
1. Install the impact bar.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
2. Install the front impact bar bolts.
Tighten
Tighten the front impact bar bolts to 22 NSm (16 lb–ft).
3. Install the front bumper impact bar nuts.
Tighten
Tighten the front impact bar nuts to 30 NSm (22 lb–ft).
4. Install the front bumper energy absorber. Refer
to”Front Bumper Energy Absorber” in this section.
5. Install the front bumper fascia. Refer to”Front
Bumper Fascia” in this section.