Daewoo NUBIRA - Remote Keyless Entry and Perimeter;Ultrasonic Anti-Theft System Maintenance and Repair; Control Module;Receiver Removal; Control Module;Receiver Installation; Siren Removal

REMOTE KEYLESS ENTRY AND ANTI–THEFT SYSTEM 9T – 5
DAEWOO V–121 BL4
MAINTENANCE AND REPAIR
ON–VEHICLE SERVICE
CONTROL MODULE/RECEIVER
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove floor console left side forward trim panel.
Refer to Section 9G, Interior Trim.
3. Disconnect the control module/receiver electrical
connector.
4. Slide the control module/receiver toward the rear of
the vehicle and remove it.
Installation Procedure
1. Install the control module/receiver by sliding it onto
its bracket.
2. Connect the control module/receiver electrical con-
nector.
3. Install the floor console left side forward trim panel.
Refer to Section 9G, Interior Trim.
4. Connect the negative battery cable.
SIREN
Removal Procedure
1. Remove several screws to boosen the forward half
of the right front wheel well splash shield.