CRUISE CONRTOL SYSTEM 9U – 15
DAEWOO V–121 BL4
ACTUATOR CONTROL CABLE
Removal Procedure
1. Press the release button on the cable adjuster, and
push the cable toward the adjuster until the adjuster
spring is compressed.
Notice : When the adjuster button is pressed, do not allow
the adjuster spring to expand to a length of more than 2 cm
(3/4 inch) or the adjuster rack will come out of the adjuster,
and will have to be re–inserted. To keep the adjuster in one
piece during adjustment, hold the cable when the adjuster
button is pressed.
2. Press the retaining tabs of the cable adjuster, and
remove the adjuster from the mounting bracket.
3. Tilt the cable housing and insert a flathead screw-
driver into one of the slots in the actuator.
4. Tilt the cable housing toward the screwdriver, so
that the cable housing retainers will release.
To Next Page
Loading...
