Daewoo NUBIRA - Heater;Air Distributor Case Assembly Installation

7A – 22IHEATING AND VENTILATION SYSTEM
DAEWOO V–121 BL4
Installation Procedure
1. Position the heater/air distributor case in the ve-
hicle.
Notice : Avoid damaging the heater core tubes by making
sure they do not contact the bulkhead opening.
2. Slowly raise the heater/air distributor case into posi-
tion.
S Insert the guide pegs through their holes in the
bulkhead.
S Hold the case in position against the bulkhead
while installing and tightening the screws on the
engine side of the bulkhead.
3. Install the screws through the bulkhead from the
engine compartment side.
S Install the two screws at the connecting block
mount.
S Install the screw above the fuel filter.
Tighten
Tighten the heater/air distributor case assembly
screws to 4 NSm (35 lb–in).
4. Install the two heater/air distributor case screws
that flank the heater core pipes.
Tighten
Tighten the heater/air distributor case assembly
screws to 4 NSm (35 lb–in).
5. Install the vacuum hose.
6. Install the two heater hoses.
7. Slide the heater hose clamps into position.