7A – 24IHEATING AND VENTILATION SYSTEM
DAEWOO V–121 BL4
HIGH–BLOWER RELAY
Removal Procedure
1. Disconnect the negative battery cable.
2. Locate the high–blower relay in the connector box
under the driver’s side of the instrument panel.
Note the colors of the wires entering the connector
from underneath: RED, BLK, PPL, ORN.
3. Pull out the relay.
Installation Procedure
1. Align the relay contacts with the relay terminal
slots.
2. Push the relay firmly into the base. The relay must
be seated and flush with the base edge.
3. Connect the negative battery cable.
BLOWER RESISTOR
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the glove box. Refer to Section 9E, Instru-
mentation/Driver Information.
3. Remove the footwell upper cover. Refer to Section
9E, Instrumentation/Driver Information.
4. Disconnect the electrical connector at the resistor.
5. Remove the mount screws from the resistor.
6. Remove the resistor from the heater/air distributor
case by gently pulling the resistor downward.
To Next Page
Loading...
