9P – 28IDOORS
DAEWOO V–121 BL4
Installation Procedure
1. Connect the body–to–door rubber grommet and the
electrical connector.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
2. With the aid of another technician, lightly secure the
rear door with the door hinge bolts.
3. Adjust the door for proper fit.
Tighten
Tighten the door hinge bolts to 25 NSm (18 lb–ft).
4. Install the rear door hold open link to the body with
the bolt.
Tighten
Tighten the door hold open link–to–body bolt to 27
NSm (20 lb–ft).
5. Connect the negative battery cable.
6. Perform the waterleak test. Refer to Section 9I,
Waterleaks.
7. Check for windnoise. Refer to Section 9J, Wind-
noise.
To Next Page
Loading...
