Daewoo NUBIRA - Oil Pump Removal; Removal Procedure

1C – 40IDOHC ENGINE MECHANICAL
DAEWOO V–121 BL4
7. Install the oil pressure switch.
Tighten
Tighten the oil pressure switch to 40 NSm (30 lb–ft).
8. Connect the oil pressure switch connector.
9. Install the right front wheel well splash shield.
10. Check the oil level. Add oil until it reaches the full
mark.
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the rear timing belt cover. Refer to ”Rear
Timing Belt Cover” in this section.
3. Disconnect the oil pressure switch connector.
4. Remove the oil pan. Refer to ”Oil Pan” in this sec-
tion.
5. Remove the oil pump/pickup tube and support
bracket bolts.
6. Remove the oil pump/pickup tube.