DOHC ENGINE MECHANICAL 1C – 13
DAEWOO V–121 BL4
Installation Procedure
1. Apply a small amount of gasket sealant to the cor-
ners of the front camshaft caps and the top of the
rear valve cover–to–cylinder head seal.
2. Install the new valve cover gasket to the valve cov-
er.
3. Install the valve cover.
4. Install the valve cover washers.
5. Install the valve cover bolts.
Tighten
Tighten the valve cover bolts to 8 NSm (71 lb–in).
6. Connect the camshaft position sensor.
7. Connect the ignition wires to the spark plugs.
8. Install the spark plug cover.
9. Install the spark plug cover bolts.
Tighten
Tighten the spark plug cover bolts to 3 NSm (27 lb–in).
10. Connect all of the necessary vacuum lines.
11. Connect the breather tube to the valve cover.
12. Connect the negative battery cable.
To Next Page
Loading...
