7A – 16IHEATING AND VENTILATION SYSTEM
DAEWOO V–121 BL4
MAINTENANCE AND REPAIR
ON–VEHICLE SERVICE
TEMPERATURE CABLE
ADJUSTMENT
Because the cable and the cable housings have fixed
lengths, it is impossible tomake a temperature cable ad-
justment.
In addition, the heater/air distributor case linkage cannot
be adjusted.
If a malfunction is suspected, verify the proper operation
of the controller and themechanical doors for the heater/
air distributor case assembly.
TEMPERATURE CONTROL CABLE
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the glove box. Refer to Section 9E, Instru-
mentation/Driver Information.
3. Slide the cable eyelet off the post on the tempera-
ture door lever.
4. Disconnect the cable retainer from the blower hous-
ing.
5. Remove the audio system trim plate. Refer to Sec-
tion 9F, Audio Systems.
6. Remove the four controller retaining screws.
7. Pull out the controller to provide clearance for re-
moval of the temperature control cable.
8. Disconnect the temperature control cable eyelet
from the post on the controller.
9. Snap the cable housing connector out of the slide
position on the controller.
To Next Page
