7A – 18IHEATING AND VENTILATION SYSTEM
DAEWOO V–121 BL4
CONTROL ASSEMBLY
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the audio system trim plate. Refer to Sec-
tion 9F, Audio Systems.
3. Remove the four controller retaining screws.
4. Pull out the controller to provide clearance for the
removal of the temperature control cable.
5. Disconnect the temperature control cable by gently
prying the cable eyelet from the post on the control-
ler. Unsnap the cable housing from the mechanical
slide. Note the location of the cable and the housing
for ease of installation.
6. Disconnect the electrical connectors.
7. Remove the vacuum hose connection block from
the mode control switch.
Installation Procedure
1. Connect the vacuum hose connection block to the
mode control switch.
2. Press the cable end eyelet onto the post on the
controller.
3. Attach the mechanical cable housing to its original
control position.
4. Connect the electrical connectors to the sockets on
the back of the controller.
To Next Page
