REAR DISC BRAKES 4E – 17
DAEWOO V–121 BL4
6. Install the inner seal into the groove in the caliper
bore.
7. Lubricate the piston with brake fluid.
8. Install the piston into the caliper.
9. Install the outer seal into the piston groove. Apply
steady hand pressure until the piston is seated in
the bore.
10. Inspect the brake shoe linings for minimum thick-
ness. Refer to”Lining Inspection”in this section. If
necessary, install new shoes.
11. Inspect the guide pins and boots. If the boots are
damaged, or if the guide pins do not slide easily,
replace these parts. Lubricate the guide pins with a
lithium soap base glycol grease or other grease
which will not deteriorate or swell the rubber boots.
12. Install the caliper. Refer to”Caliper”in this section.
To Next Page
