DOHC ENGINE MECHANICAL 1C – 43
DAEWOO V–121 BL4
3. Install a new oil pump–to–crankshaft seal. Coat the
lip of the seal with a thin coat of grease.
4. Coat the threads of the oil pump/pickup tube and
support bracket bolts with Loctite± 242.
5. Install the oil pump/pickup tube and the bolts.
Tighten
Tighten the oil pump/pick–up tube and support brack-
et bolts to 10 NSm (89 lb–in).
6. Install the oil pan. Refer to ”Oil Pan” in this section.
7. Connect the oil pressure switch connector.
8. Install the rear timing belt cover. Refer to ”Rear
Timing Belt Cover” in this section.
9. Connect the negative battery cable.
To Next Page
