Select Start from the dropdown list to enable smart codec
function. The DVR can auto reduce the video bit stream of the
non-important surveillance object to save the storage space.
Compression: System supports H.264H, H.264, H.264B, and
MJPEG.
H.264H: It is the High Profile compression algorithm. It has
the high encode compression rate. It can achieve high
quality encode at low bit stream. Usually we recommend
this type.
H.264 is the general compression algorithm.
H.264B is the Baseline algorithm. Its compression rate is
low. For the same video quality, it has high bit stream
requirements.
It is to set video resolution. The higher the resolution is, the
better the video quality is.
PAL：1～25f/s；NTSC：1～30f/s.
Main stream: You can set bit rate here to change video
quality. The large the bit rate is , the better the quality is.
Please refer to recommend bit rate for the detailed
information.
Extra stream: In CBR, the bit rate here is the max value.
In dynamic video, system needs to low frame rate or
video quality to guarantee the value. The value is null in
VBR mode.
Recommended bit rate value according to the resolution and
frame rate you have set.
Here you can set the P frame amount between two I frames. The
value ranges from 1 to 150. Default value is 50.
Recommended value is frame rate *2.
It includes G711a/G711u/PCM.
Please select from the dropdown list. There are two options:
Normal/HDCVI. In the normal mode, the audio signal comes
from the Audio In. In the HDCVI mode, the audio signal comes
from the coaxial cable of the camera.
This function allows you to verify the video is tampered or not.
Here you can select watermark bit stream, watermark mode and
watermark character. Default character is DigitalCCTV. The max
length is 85-digit. The character can only include number,
character and underline.
5.5.1.3.2 Snapshot
From main window->Setup->Camera->Encode->Snapshot, the snapshot interface is shown as in Figure
5-24.
To Next Page
Loading...
