Figure 5-45
Check the box to enable send SMS/SMS activate/tel activate function.
Input sender/caller cellphone number and then click to add the cellphone user to the list.
Select a number in the list and then click to delete current number.
Send SMS: Check the box to enable this function. Various kinds of alarm can trigger the DVR to
send out alarm message to the receiver.
SMS activate: Check the box to enable this function. The user can send out the message to the
receiver to enable/disable 3G module.
Telephone activate: Check the box to enable this function. The user can call the 3G user to
enable/disable 3G module.
Click OK to complete the setup.
5.5.2.5 PPPoE
From main window->Setup->Network->PPPoE, the PPPoE interface is shown as in Figure 5-46.
Input the PPPoE user name and password you get from the IPS (internet service provider) and enable
PPPoE function. Please save current setup and then reboot the device to get the setup activated.
Device connects to the internet via PPPoE after reboot. You can get the IP address in the WAN from the
IP address column.
Please note, you need to use previous IP address in the LAN to login the device. Please go to the
IP address item to via the device current device information. You can access the client-end via
this new address.
Figure 5-46
5.5.2.6 DDNS
To Next Page
Loading...
