Note
This function is for whitelist only.
5.5.2.7.2 Sync Time Right
From main window->Setup->Network->IP filter->Sync time right, the sync time interface is shown as
Figure 5-49.
After you set sync time whitelist, only the specified IP address can sync or change device time. It is to
avoid multiple hosts to sync or change time with the device at the same time.
Please check the Enable box to enable this function and then click Add button to add the corresponding
address, and then click Save button to complete the setup. From main
menu->Setup->System->General->Date and time, change device time or check the IPC time sync box to
enable time sync function.
Figure 5-49
Please refer to the following sheet for detailed information.
Input the device IP address you want to add.
Input the start address and end address of the IP segment you
want to add.
The IP address adopts IPv4 mode such as 172.16.5.10.
The IP address adopts IPv6 mode such as
aa:aa:aa:aa:aa:aa:aa:aa.
Input the mac address you want to add.
5.5.2.8 Email
After you set email function, system can send out an email once there is an alarm, video detection event,
abnormality event, intelligent event and etc.
From main window->Setup->Network->Email, the email interface is shown as in Figure 5-50.
To Next Page
Loading...
