The of the PTZ camera is the center position of the video.
Electronic mouse, move it on the interface to control the
PTZ direction.
Fast positioning button. Click it first and then click any
position in the video. Left click mouse, you can view the
video from the specified position.
It is to control PTZ movement speed. The higher the
value is, the faster the speed is.
For example, the step 8 speed is faster than step 1.
Click add button and then click to save.
Now you complete one group position, you can view at the list. See Figure 5-87.
Figure 5-87
Repeat the above steps to set at least three group positions.
Note
For one PTZ camera, there must be three calibration groups. System max supports 8 group
positions. Please make sure the calibration position is accurate.
For the first calibration group position, please select the reference objects at the far distance to
enhance the trigger accuracy.
Click OK button to complete the calibration setup, you can go back to the smart track interface, the status
is shown as .
5.5.3.8 Alarm
Before operation, please make sure you have properly connected alarm devices such as buzzer. The
input mode includes local alarm/network alarm/IPC external alarm/IPC offline alarm.
To Next Page
Loading...
