Danfoss iC2 - Page 155

Application Guide | iC2-Micro Frequency Converters
Use this parameter to select whether the drive setup selection is controlled via the terminals (digital input) and/or via the fieldbus.
 NOTICE
This parameter is active only when P 5.5.1.1 Control Place Selection is set to [0] Digital and control word.
Default value: 3 [Logic OR] Parameter type: Selection
Parameter
number:
855 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name Selection description
0 Digital input A digital input triggers the setup selection.
1 Bus A serial communication port or the fieldbus triggers the setup
selection.
2 Logic AND The fieldbus/serial communication port and a digital input
trigger the setup selection.
3 Logic OR The fieldbus/serial communication port or a digital input triggers
the setup selection.
P 5.5.2.7 Preset Reference Select
Use this parameter to select whether the drive Preset Reference selection is controlled via the terminals (digital input) and/or via the
fieldbus.
 NOTICE
This parameter is active only when P 5.5.1.1 Control Place Selection is set to [0] Digital and control word.
Default value: 3 [Logic OR] Parameter type: Selection
Parameter
number:
856 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name Selection description
0 Digital input A digital input triggers the preset reference selection.
1 Bus A serial communication port or the fieldbus triggers the preset
reference selection.
Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254 | 155