Table 9: Menu Screen
Menu Function
Quick Access Quick access for setting up a drive quickly. See 3.2.4.3.2 Quick Access Navigation.
All Parameters View and set the parameters.
Events Event list (including fault and warning that has occurred in the drive).
Display Setting Set language and adjust the display backlight.
Backup & Restore Backup and restore the drive information.
Basic navigation handling techniques
l To navigate through and within the different functionalities or parameter groups, use the navigation buttons of the Control Panel
2.0 OP2.
l Use the Back button to navigate to a higher level, and the OK button to navigate to a lower level.
3.2.6.4 Parameter Group Screens and Overall Navigation
All Parameters menu includes all parameters for configuration. A typical parameter group screen is shown as below.
Figure 13: Parameter Group Screen
The following information is contained in the parameter group screen:
Table 10: Legend Table
Legend Description
1 Control state of the drive. The value in the middle without setpoint icon shows the output frequency.
2 Name of the menu, group, and parameter that is currently active in the drive.
3 Group, sub-group, or parameter list.
4 Scrollbar
3.2.6.5 Changing Selections in a Parameter
In this example, the parameter P 5.5.4.1 Ramp 1 Type Selectoris considered. When a parameter has selections, a black highlight is active
on the parameter index and name, as shown.
32 | Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254
Application Guide | iC2-Micro Frequency Converters
To Next Page
Loading...
