Danfoss iC2 - 7.9.2.3 Relay (Menu Index 9.4.3)

Application Guide | iC2-Micro Frequency Converters
Selection number Selection name Selection description
161 Running Reverse The output is high when the frequency converter is running
counterclockwise (the logical product of the status bits Running
AND Reverse).
165 Local Ref. Active The output is high when local reference is activated.
166 Remote Ref. Active The output is high when remote reference is activated.
167 Start Command Active The output is high when there is an active start command, and
no stop command is active.
168 Drive in Local Mode The output is high when the frequency converter is in Local
mode.
169 Drive in Remote Mode The output is high when the frequency converter is in Remote
mode.
193 Sleep Mode The frequency converter/system has entered sleep mode.
194 Lost Load Function A lost-load condition is detected.
P 9.4.2.3 T15 DO ON-Delay
Enter the digital output on delay time.
Default value: 0.01 Parameter type: Range (0.00–600.00)
Parameter
number:
534 Unit: s
Data type: uint16 Access type: Read/Write
P 9.4.2.4 T15 DO OFF-Delay
Enter the digital output Off delay time.
Default value: 0.01 Parameter type: Range (0.00–600.00)
Parameter
number:
535 Unit: s
Data type: uint16 Access type: Read/Write
7.9.2.3 Relay (Menu Index 9.4.3)
P 9.4.3.1 Function Relay
Select the function to control the output relays.
Default value: 9 Parameter type: Selection
Parameter
number:
540 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254 | 239