Danfoss iC2 - 3.2.4 Control Panel Basic Configuration; 3.2.4.1 Overview of Control Panel Basic Configuration; 3.2.4.2 Understanding Readout Screens

Application Guide | iC2-Micro Frequency Converters
3.2.4 Control Panel Basic Configuration
3.2.4.1 Overview of Control Panel Basic Configuration
Basic configurations of the control panel include:
l Readout status of the motor and the drive which includes warnings and faults.
l Navigate to the menus to view or change parameter settings for the drive.
After the drive is powered up, press the Home/Menu button to toggle between status display and main menu. Use the Up/Down buttons
to select items, and press OK button to confirm selection.
e30bv048.10
Status Display
(MON status indicator light is on)
Main Menu
(PGM status indicator light is on)
Q1: Motor Data
Quick
Access
Full
Parameters
Events
Information
Reference
Setting
(Hz)
(1)
Output
Frequency
(Hz)
Motor
Current
(A)
Torque
(Nm)
Udc
Voltage
(V)
Power
(kW)
Customer
Readout
(Unit)
(3)
Feedback
(Unit)
(2)(3)
Reference
(%)
(2)
Note: (1) Local mode only. (2) Remote mode only. (3) The status is only shown when the corresponding function is enabled. (4) For AMA
execution, refer to
chapter Automatic Motor Adaptation (AMA)
. If parameter P5.4.3 Motor Control Principle is set as [0] U/f, no need to execute AMA.
Faults
Application
Selection
P4.2.1.1 Motor Type
*[0] IM Motor
PM Motor
[1] SPM or [3] IPM
P4.2.1.3 AMA Mode
(4)
P4.2.2.1 Nominal Power
P4.2.2.2 Nominal Voltage
P4.2.2.3 Nominal Current
P4.2.2.4 Nominal Frequ-
ency
P4.2.2.5 Nominal Speed
P4.2.1.2 Number of Poles
P4.2.2.3 Nominal Current
P4.2.2.5 Nominal Speed
P4.2.3.7 Motor Cont.
Rated Torque
P4.2.4.1 Back EMF
P4.2.1.2 Number of Poles
P5.4.1 Application Selection
*[20] Speed Control Mode
[21] Process Control Mode
[22] Multi Speed Control Mode
[23] 3-wire Control Mode
[24] Torque Control Mode
P5.5.3.3 Reference Maximum
P5.5.3.4 Reference Minimum
P5.5.4.2 Ramp 1 Accel. Time
P5.5.4.3 Ramp 1 Decel. Time
P2.3.14 Max Output Frequency
P5.8.2 Motor Speed High Limit
Parameter group 1st level:
G1 Grid
G2 Power Conversion & DC-link
G3 Filters & Brake Chopper
G4 Motor
G5 Application
G6 Maintenance & Service
G8 Customization
G9 I/O
G10 Connectivity
Q2:
Motor
Control
Q3:
Figure 2: Operation with Control Panel
3.2.4.2 Understanding Readout Screens
When the drive is in ready state, the control panel display shows the Home screen in the main display. By default, as a factory setting, the
Home screen shows the reference setting in local mode, as shown in the figure below.
Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254 | 23