Danfoss iC2 - 7.7.2 Software Information (Menu Index 6.2); 7.7.3 Cooling Fan (Menu Index 6.5)

Application Guide | iC2-Micro Frequency Converters
7.7.2 Software Information (Menu Index 6.2)
P 6.2.1 Application Version
Use this parameter to view the combined software version consisting of power software and control software.
Default value: – Parameter type: –
Parameter
number:
1543 Unit: –
Data type: VisibleString Access type: Read
P 6.2.2 SW ID Control Card
Use this parameter to view the control board software version number.
Default value: – Parameter type: –
Parameter
number:
1549 Unit: –
Data type: VisibleString Access type: Read
P 6.2.3 SW ID Power Card
Use this parameter to view the power card software version number.
Default value: – Parameter type: –
Parameter
number:
1550 Unit: –
Data type: VisibleString Access type: Read
P 6.2.7 ECP SW Version
View the ECP ID number.
Default value: – Parameter type: –
Parameter
number:
1548 Unit: –
Data type: VisibleString Access type: Read
7.7.3 Cooling Fan (Menu Index 6.5)
P6.5.1 Fan Control Mode
Use this parameter to select the fan control mode.
Default value: 7 [On when Inverter is on, otherwise off] Parameter type: Selection
Parameter
number:
1452 Unit: –
Data type: enum Access type: Read/Write
Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254 | 191