Danfoss iC2 - 7.6.11.2 Feedback (Menu Index 5.12.4)

Parameter
number:
1892 Unit: %
Data type: int16 Access type: Read
P 5.12.1.4 Process PID Gain Scaled Output
This parameter shows the output value from the process PID controller after reaching a clamp limit and scaling the resulting value with
consideration to the gain.
Default value: 0.0 Parameter type: Range (-200.0–200.0)
Parameter
number:
1893 Unit: %
Data type: int16 Access type: Read
P 5.12.1.5 Feedback Value
Use this parameter to view the feedback resulting from the selection of scaling in P 5.5.3.1 Reference Range, P 5.5.3.3 Reference
Maximum, and P 5.5.3.4 Reference Minimum.
Default value: 0.000 Parameter type: Range (-4999.000–4999.000)
Parameter
number:
1652 Unit: Process Ctrl Unit
Data type: int32 Access type: Read
7.6.11.2 Feedback (Menu Index 5.12.4)
P 5.12.4.1 Feedback 1 Resource
Use this parameter to select which drive input is treated as the feedback source.
Default value: 0 [No function] Parameter type: Selection
Parameter
number:
720 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter:
Selection number Selection name
0 No function
1 Analog Input 33
2 Analog Input 34
4 Frequency Input 18
P 5.12.4.2 Feedback 2 Resource
Use this parameter to select which drive input is treated as the source of the feedback.
178 | Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254
Application Guide | iC2-Micro Frequency Converters