Danfoss iC2 - Page 179

Application Guide | iC2-Micro Frequency Converters
Default value: 0 [No function] Parameter type: Selection
Parameter
number:
722 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter:
Selection number Selection name
0 No function
1 Analog Input 33
2 Analog Input 34
4 Frequency Input 18
P 5.12.4.3 Feedback 1 Conversion
Use this parameter to select a conversion for the Feedback 1 signal. To leave the feedback signal unchanged, select [0] Linear.
Default value: 0 [Linear] Parameter type: Selection
Parameter
number:
760 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter:
Selection number Selection name
0 Linear
1 Square root
P 5.12.4.4 Feedback 2 Conversion
Use this parameter to select a conversion for the Feedback 2 signal. To leave the feedback signal unchanged, select [0] Linear.
Default value: 0 [Linear] Parameter type: Selection
Parameter
number:
762 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter:
Selection number Selection name
0 Linear
1 Square root
Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254 | 179