Danfoss iC2 - 3.2.4.3.3 Parameter Group Screen and Navigation

Quick
Access
P4.2.1.1 Motor Type
q1: Motor Data
*[0] IM Motor
PM Motor
[1] SPM or [3] IPM
P4.2.1.3 AMA
q2:
P5.4.1 Application Selection
*[20] Speed Control Mode
[21] Process Control Mode
[22] Multi Speed Control Mode
[23] 3-wire Control Mode
[24] Torque Control Mode
P5.5.3.3 Reference Maximum
P5.5.3.4 Reference Minimum
P5.5.4.2 Ramp 1 Accel. Time
P5.5.4.3 Ramp 1 Decel. Time
P2.3.14 Max Output Frequency
P5.8.2 Motor Speed High Limit
P4.2.2.1 Nominal Power
P
4.2.2.2 Nominal Voltage
P4.2.2.3 Nominal Current
P4.2.2.4 Nominal Frequency
P4.2.2.5 Nominal Speed
P4.2.1.2 Number of Poles
P4.2.2.3 Nominal Current
P4.2.2.5 Nominal Speed
P4.2.3.7 Motor Cont. Rated
Torque
P4.2.4.1 Back EMF
P4.2.1.2 Number of Poles
Application
Selection
q3:
Motor
Control
e30bk031.10
Figure 5: Quick Access Functions
3.2.4.3.3 Parameter Group Screen and Navigation
Overview
Press the Up/Down buttons to select the all parameters menu. See overview of full parameters in 3.2.4.3.1 Overview of Menu Group
Screen and Navigation. Press OK to enter the sub-menus.
To navigate through and within the different parameter groups, use the navigation buttons of the control panel.
l Use the Up/Down button of the control panel to navigate to different parameter groups.
l The Back button is used to navigate to a level higher and the OK button to a level lower in the parameter/parameter group screens.
Figure 6 shows how to navigate to a parameter and the example considered is P 2.3.1 Overvoltage Controller Enable.
e30bj975.10
OK
OK
OK
Figure 6: Parameter Navigation
26 | Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254
Application Guide | iC2-Micro Frequency Converters