P 10.2.6 Slave Timeout Errors
This parameter shows the number of slave timeout errors.
Default value: 0 Parameter type: Range (0–4294967295)
Parameter
number:
885 Unit: –
Data type: uint32 Access type: Read
P 10.2.7 Reset FC Port Diagnostics
Reset all FC port diagnostic counters.
Default value: 0 Parameter type: Selection
Parameter
number:
888 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name
0 Do not reset
1 Reset counter
260 | Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254
Application Guide | iC2-Micro Frequency Converters
To Next Page
Loading...
