V0913, 7.10
7.2.5. Manual positioning
In manual positioning view mode the axes values are shown at large. Axes can be selected
and while selected the position can be controlled by turning the handwheel.
The teach indicator:
When the teach indicators arrow is pressed, standing in between actual value and
programmed value, the value is tought to the program step.
External Handterminal (optional)
The manual positioning functionality can be expanded by using an external handterminal. This
handterminal allows the operator to remotely control the handwheel functionality, including
axes selection and bend selection, and teach found axes positions to the program.
To Next Page
Loading...
