V0913, 1.10
1.5.6. The Auto menu and Manual menu, production modes
A product program can be executed via the Auto mode. In Automatic mode, a complete
program can be executed bend after bend. In the Auto mode the Step mode can be selected
to have each bend started separately.
The Manual mode of the control is an independent production mode. In this mode, one bend
can be programmed and executed. It is typically used to test the behaviour of the bend
system.
More information about this can be found in chapters 7 and 8.
1.5.7. Back-up data, external storage
Both product and tool files can be stored externally. Depending on the configuration, these
files can be stored on a network or on a USB storage device. This facilitates a back-up of
important data and the possibility to exchange files between Delem controls.
More information about this can be found in chapter 9.
To Next Page
Loading...
