Delem DA-66T - Manual Mode, Parameter Explanation; Product Properties; Bend Parameters

V0913, 8.2
8.1.1. Manual mode, parameter explanation
Following is a list of the available parameters in Manual mode.
Product Properties
Thickness
Program the thickness of the sheet.
Material
Selection of one of the programmed materials, which are used to calculate the bending
depths. The control contains 4 pre-programmed materials. In total, 99 materials can be
programmed on the control. The materials can be programmed on the Materials page in
the Settings mode.
Bend parameters
Method
Select the required bending method. The control supports 4 methods:
• Air bend
• Bottoming
• Hemming
• Hemming & bottoming
The bend methods have been explained in more detail on the Basic Data page in the
Program mode.
Bending length
Program the bending length of the sheet.