V0913, 5.11
5.4. Assignments
5.4.1. Introduction
The Assignments are parameters with which the bend sequence computation is controlled.
The assignments screen is opened from the tool configuration screen with the function key
Assignm.
Automatic bend sequence computation works with several conditions in order to find an
optimum between a minimum production time, handling possibilities without product/machine
and product/tool collision.
In order to find one of the optimums you must program several computation parameters with
which the bend sequence can be computed. Some of these parameters are machine-related
and some are related to product accuracy, handling possibilities and turn times.
Functions
Load defaults
Load default assignment settings. It is possible to determine a set of assignments which have
the most optimal values for your situation. This set can be stored by tapping Save As Default.
While programming another product you can recall this previous fixed set by loading the
values via Load Defaults.
Save As Default
Save the current settings as default assignments settings.
Cancel
To Next Page
Loading...
