V0913, 10.41
10.8. Machine upper side
In this tab the machine geometry for the upper beam, as a profile, can be programmed. This
information is used in the collision detection of collisions with product and machine.
When e.g. utilities are added to the machine in special cases, these can be programmed as a
special machine shape to enable the collision calculations to take this into account.
In most instances there is only one shape programmed.
The shapes of your machine are drawn in the same way as for the punches and dies. Like
with the tools the right hand side of the drawing is the back gauge position of the machine.
To have a more detailed view in the library tab, tap View and use Graphical.
To Next Page
Loading...
