V0913, 4.6
4.4. Tool segmentation
When using segmented tools, from which desired sized tools can be composed, the control
can support this and can help to generate the appropriate segmentation.
In below paragraph the functionality for segmentation is explained, including the use of the
three views on the tool setup. Next to the Tool Setup screen the ability to have segmentation
features available is depending on the programmed segments for each tool. This
programming can be done in Machine mode under the Punches and Bottom dies libraries.
More on programming of segments in the Tool library can be found at the end of this
paragraph.
From within the Tool Setup screen there are three available view modes. With the selection
buttons on the left side of the machine front view following views can be chosen:
To Next Page
Loading...
