V0913, 9.14
9.6. Default values
Y opening default
Default Y-axis opening value.
The value programmed here is used as initial value for the parameter 'Y-axis opening' in
the Program mode.
Default pressing speed
Default pressing speed, used as initial value for the parameter 'pressing speed' in a new
program.
Default wait for retract
Default value for the parameter 'wait for retract' in a bend program. This parameter
determines the control behaviour in a bend program. Initially the parameter 'wait for
retract' is set to the value programmed here during postprocessing and during
programming.
The default value of this parameter: yes.
Default step change code
Default value for the parameter 'step change code' in a bend program. This parameter
determines the moment of step change in a bend program. Initially the code parameter
is set to the value programmed here during postprocessing and during programming.
The default value of this parameter is: UDP.
The step change codes have been explained in more detail on the Optional Data page
in the Program mode.
Default delay time
During the postprocessing, the waiting time of the X-axis at step change is set to zero.
To Next Page
Loading...
