V0913, 9.15
With this parameter you can preset a longer waiting time when needed for product
handling.
Default dwell time
Default value for the parameter 'dwell time' in a bend program.
Default hem opening
The hem bend can be made with a certain opening distance between the 2 flanges. The
hem opening value will be used calculating the beam position in the hemming process.
This programmed default value will be used when programming the product with hem
bend graphically in the Drawing mode or by programming a new program in the
Program mode. The starting value is 0.0mm to get the two flanges of a hem bend
completely upon each other without any space between the flanges.
The default value of the parameter = 0.00
Default dimensions
A graphical product drawing can be made in outside or inside dimensions. This
parameter defines the default value of the parameter "dimensions (D1)" when creating a
graphical drawing.
To Next Page
Loading...
