V0913, 9.11
9.5. Program settings
Angle correction computation
Parameter to enable the input of 'measured angles' for which corrections will be
calculated.
disabled => no correction computation from measured angles.
enabled => the operator can enter the measured angle of a bend and haveangle
corrections calculated.
With this parameter set, the field 'measured angle' becomes available in the corrections
window. The angle corrections can be programmed on the Angle Corrections page in
the Automatic mode.
Angle correction database
Parameter to enable the database with angle corrections.
Angle corrections are entered in production mode (Auto mode). These corrections are
stored in the product program.
The Angle correction database enables the possibility to store these corrections in a
database. In this way corrections that have once been entered for certain bends remain
available for future use in other products.
With this setting enabled, the control checks during production whether corrections for
similar bends are present in the database. If corrections for certain bends are available,
then they will be offered. On other occasions, corrections can be interpolated and
offered.
The correction database is adjusted by entering new corrections during production.
When the database is enabled with this parameter, all new-entered corrections are
stored in the database.
To Next Page
Loading...
