Delem DA-66T - Position Corrections

V0913, 10.40
10.7. Position corrections
X position correction
When the actual, mechanical axis position is not corresponding with the displayed value
than is it possible to correct the position with this parameter. Program the calculated
difference.
Example:
- When the programmed and displayed value = 250 and the actual, mechanical position
value = 252 the CX parameter = -2.
- When the programmed and displayed value = 250 and the actual, mechanical position
value = 248 the CX parameter = +2.
In case there are several X-axes installed, a separate parameter is available for each X-
axis.